Service
Schedule
First Scheduled Maintenance: 2.25 hours
Because of their unique design features, Spring Models (FLSTS and FXSTS)
require
first scheduled maintenance at 500 miles.
Other models require first scheduled maintenance at 1000 miles.
1.
Change engine oil and filter
2. Inspect air cleaner and
service as required
3.
Change primary chaincase lubricant and clean magnetic drain plug,
check/adjust primary chain
4.
Check clutch adjustment
5.
Change transmission lubricant & clean the magnetic drain plug
6.
Check and adjust drive belt
7.
Lube the foot shift/brake lever bearings
8.
Inspect brake pads and discs for wear
9.
Check brake fluid reservoir levels and conditions
10.
Inspect oil lines and brake system for leaks
11.
Lubricate: front brake hand lever, throttle control cables,
throttle,
clutch
control cable and hand lever, jiffy stand
12.
Lubricate and adjust Springer steering hand bearings
13.
Check, adjust operation of enrichener*
14.
Inspect fuel valve*, lines and fitting for leaks
15.
Check tire pressure and inspect tread
16.
Check wheel spoke tightness
17.
Check battery electrolyte level* and clean battery connections
18.
Check operation of all electrical equipment and switches
19.
Check cruise control disengage switch & components*
20.
Adjust Springer Rocker bearings*
21.
Check air suspension pressure operation and leakage
22.
Check stabilizer links* and engine mounts
23.
Check tightness of all critical fasteners: hand controls, brake
system,
axle nuts,
front fork components, riser and handle bar fasteners
24.
Check engine idle speed adjustment
25.
Road Test
26.
Bike Wash
* if
applicable
5,000 Mile Maintenance: 2.25 hours
5,000, 15,000, 25,000, 35,000, 45,000
1. Change engine oil and filter
2.
Inspect air cleaner and service as required
3. Change primary chaincase lubricant and
clean magnetic drain plug.
Check/adjust primary chain
4. Check clutch adjustment
5. Change transmission lubricant and clean
the magnetic drain plug. Check/adjust
primary
chain
6. Check and adjust belt
7. Lube the foot shift/brake lever bearings*
& speedometer cable*
8. Lubricate the Springer steering head
bearings
9. Inspect brake pads and discs for wear
10. Check brake fluid reservoir levels and
conditions
11. Inspect oil lines and brake system for
leaks
12. Lubricate the following: front brake hand
lever, throttle control cables,
throttle,
clutch control cable and hand lever, jiffy stand
13. Check, adjust operation of enrichener
14. Inspect fuel valve*, lines and fittings for
leaks
15. Check tire pressure and inspect tread
16. Check wheel spoke tightness*
17. Check battery electrolyte level* and clean
battery connections
18. Check operation of all electrical equipment
and switches
19. Check cruise control disengage switch &
components*
20. Inspect spark plugs
21. Check air suspension pressure operation and
leakage*
22. Check stabilizer links and engine mounts
23. Lubricate hinges, latches-fuel door, Tour
Pak, saddlebags*
24. Check ignition timing and vacuum hose*
25. Check engine idle speed adjustment
26. Road Test
27. Bike Wash
* if applicable
